![]() This is /dev/ttyS0 on most Linux distributions. If it is not, press A, and enter the correct device. Verify that the listed serial port is the same one that is connected to the target board.Use the Down-arrow key to scroll down and select the Serial port setup option, and press Enter. A menu of configuration should appear.Start minicom on your host machine in configuration mode.This requires the root login or prepending each command with sudo. The commands discussed in this section are meant to be performed by a privileged user account. The i.MX25PDK uses a serial debug port to communicate with the host machine. Connect the power supply to your board.If you are using an Ethernet hub or switch, connect the board to the hub with a straight-through Ethernet cable, then connect the hub to the second Ethernet port of your workstation.If you are using a cross-over cable, connect the Ethernet port of the debug board to the second Ethernet port of your workstation.Connect the debug port of the debug board to the serial port of your workstation using the null modem cable.Once you have all of the necessary components, you should perform the following steps: Ethernet Crossover Cable or Ethernet hub/switch and Ethernet Patch Cables.To boot the Freescale i.MX25 PDK, you will need the following items: An available serial port on your Development Host.One to communicate normally with your LAN/WAN while installing host packages, the other to communicate solely with the target board. If you are booting your root file system over the network, you will need two network cards installed and configured in the Development Host.These are found in the output directory of your online build, or in the directory build_armv5l-timesys-linux-/images/ on the command line. A copy of the Linux Kernel (uImage-2.6.31-ts-armv5l) and Root File System () for the Target Board downloaded from Factory.Root or sudo permission on the Development Host.An internet connection on the Development Host.While you can use nearly any modern Linux distribution released in the last 24 months, Timesys recommends one of the following: To properly boot a board using software from Timesys, your host machine must meet the following requirements: This document will describe in detail the procedures for booting a Linux kernel image and mounting a root file system over NFS on the Freescale i.MX25 PDK. Disable SELinux and Firewall on Fedora Core. ![]() New York Internet, iXsystems, and RootBSDĬopyright © 2000-2022 Dan Langille. New York Internet, iXsystems, and RootBSD This siteġ1 vulnerabilities affecting 126 ports have been reported in the past 14 days Where filename is the board-specific u-boot.imx file to boot with. Port on your computer, power on the board, then run imx_usb To use this, connect the OTG port of your i.MX board to a USB host Use the OTG port, Vybrid systems use the UART port. U-Boot in nonvolatile media such as nand flash or eeprom. Used to "unbrick" a system which has a corrupted or missing copy of Transferred to the system over an OTG or UART connection. This program boots an i.MX or Vybrid system using a copy of U-Boot 444322 sysutils/u-boot-imx-serial-loader/pkg-plist.444322 sysutils/u-boot-imx-serial-loader/distinfo.444322 sysutils/u-boot-imx-serial-loader/Makefile.444322 sysutils/u-boot-imx-serial-loader.Non port: sysutils/u-boot-imx-serial-loader/distinfo NOTE: the Look for it right after the Description: on each port's home page. Want a good read? Try FreeBSD Mastery: Jails (IT Mastery Book 15) FreshPorts - sysutils/u-boot-imx-serial-loader/distinfoĪs an Amazon Associate I earn from qualifying purchases.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |